Electrical Quality Control Inspector - Prudhoe Bay, Alaska

The incumbent may be required to work a flexible work rotational schedule. 

The position is located on the North Slope and requires a flexible rotational work schedule. Relocation assistance to Alaska is not provided; however, transportation between Anchorage and Prudhoe Bay is provided. Room and meals are provided while in Prudhoe Bay.

This position performs quality control functions to assure compliance with project and Owner requirements under general supervision. Receives instruction on specific assignment objectives and work is reviewed by general supervision.

Essential Job Functions:
- Maintain compliance with established project, Corporate and customer quality assurance and control requirements
- Review engineering drawings and track quality progress based on scope of work document
- Updates Quality Control files
- Will perform field and/or Fab Shop inspections
- Assist in the processing of installation procedures
- Notifies supervisors of any discrepancies found between work completed and material installed and Owner quality
requirements
- Performing special process and field installation inspections and surveillance of equipment and materials
- Attend training sessions, seminars, and appropriate educational classes as required by department
- Possess current knowledge of Engineering, Business Administration, quality control and organizational practices
- Other duties as assigned
Physical Demand/Work Environment:
The physical demands described here are representative of those that must be met by an employee to successfully
perform the essential functions of this job. Reasonable accommodations may be made to enable individuals with
disabilities to perform the essential functions.
While performing the essential functions of this job, the employee must have ability to stand, walk on level, uneven and
slippery surfaces; sit, squat, kneel, reach through low and high ranges and exhibit normal balance and coordination.
These basic physical requirements are essential for safe performance of the job in harsh environments with exposure to
very cold temperatures and while wearing arctic gear.
- Lift 40 lbs from floor to knuckles x 2 with a 12 second interval
- Lift 40 lbs from floor to waist x 2 with a 12 second interval
- Lift 12 lbs from floor to above head/crown level with a 12 second interval
- Repetitively lift 30 lbs from floor to knuckles x 10 self-paced but continuous with 12 second intervals between each lift
- Carry Test: Carry 40 lbs with two hands for 50 feet x 2; self-paced, but continuous; (allow a 60 second rest break
between carry tests, i.e. after 50 feet.)
- Climb Stairs: Climb up and down 12 steps x 10 for a total of 120 steps; self-paced, but continuous, (allow 60 second rest
breaks after each up and down climb of 40 steps)
- Lift, Carry and Climb: While carrying 35 lbs in one hand and holding onto a railing with the other hand for safety, walk
up and down 12 steps x 2 for a total of 24 steps; self-paced but continuous, (allow 60 second rest break 12 steps up and
down.)
- Slanted Ladder: Climb up and down 15 rungs x 6 for a total of 90 rungs (allow a 60 second rest break after climbing up
and down each set of 30 rungs)
- Repetitive Stoop Test: Perform from standing position, bend forward at waist as far as possible without bending the knees
with hands reaching toward the floor x 5, self-paced, but continuous.
- Repetitive Kneel Test: Perform from standing, kneel on one knee, and alternate from left to right knee, x 5 each knee
- Repetitive Squat Test: Perform a functional squat and stand x 5
- Twist and Flex Test: Perform from standing alternate toe touches x 5 to each side to assess ability to twist and flex the
trunk repetitively